Tap Inserts Twin Pack - with Special Fitting Tool

Tap Inserts Twin Pack

In some homes, taps can flow up to 18 litres a minute.

Together with the world leader in flow and stream control technology, Save Water Save Money has developed the Tap Insert Twin Pack, designed to reduce the flow rate on two taps around the home to 5 litres a minute, saving up to 12 litres a minute and reducing your gas or electricity bills by reducing the amount of water used.

Key Benefits:

• Reduces waste of water and energy, by up to 60% on most taps.

• No noticeable difference in performance of the tap.
• No need to replace external external chrome or steel parts - simply replace the internal plastic parts.
• Plastic fitting tool included, prevents marking of taps – allows job completion in minutes.
• Fits up to 85% of taps with screwed outlets.
• Flow rate of 5 litres a minute compared to standard wasteful output of up to 15 litres.
• Offers savings up to 300% on water usage on taps with uncontrolled stream.
• Easy to fit - tool provided
• Converts wash basins in the home or workplace with minimum interruption.
• Fully aerated stream limiting splash
• High quality construction.
• Contains anti limescale materials approved to BS6920 for potable water Aerated stream.
• Reduces detergent use when washing - thereby helping the environment.
• Enhanced velocity of stream added to aeration gives improved comfort of use.

• Use of original housing retains design and aesthetics of original tap.

Kit Contents:

• 4 adaptor rings ( 2 x black & 2 x grey) to select for your present housing when fitting.
• 2 x 5 litres a minute aerator with Intelligent Flow Control

Fitting Instructions:

1. Slide the opening of the blue tool around the end of the tap. There are various size fittings so make sure the tool fits snugly.
2. Twist anticlockwise until the end of the tap comes away from the spout.
3. Remove the original insert from the housing.
4. From the components, select one to replace the old insert, as follows (you’ll find only one component will fit):
   • The grey ring is for housings that have an internal shoulder at the outlet of the housing.
   • The black ring is for housings that have no visible shoulder.
   • For small housings (JR size) just insert the aerator.
5. Install the converter ring into the tap housing and using original gasket replace on to spout hand tight. If using the grey or black converter ring, insert the aerator fully into the ring until the top of the aerator is flush with the top of the ring.

Will it fit my taps?

The tap insert requires the tap end to have two straight edges. It will fit the majority of taps with a screwed outlet housing. It is not suitable for large bath taps. The inserts should not affect the performance of your taps, merely regulate the flow to 5 litres per minute.